strip light installation A

With the continuous changes in the form of home decoration ceiling, it has also led to an increasing number of types of lighting fixtures installed indoors. For example, in the past, most of the lights installed in households were ceiling lights or chandeliers. But now when you observe, you will find that there are tube lights, spotlights, and even light strips.

 Especially the appearance of grooves in the ceiling of our home has led to the extensive use of light strips. But if the light strip is not installed properly, it is easy to have problems with not lighting up or flashing. Therefore, for the light strips installed during home decoration, everyone should master the specific installation methods. In this article, HSONG Lighting will answer the question of the installation method of the light strip for everyone.

 （1） I don't know if you have seen the connection of light strips. According to our requirements, there are various sizes of light strips available. A light strip may reach several tens of meters, but there are also short ones ranging from 1 meter to 2 meters. Therefore, the specific connection of the light strip installed in our home needs to be determined first. The light strips installed in our ceiling are mostly installed in rows of light strips. Therefore, the following steps should be followed to determine the connection of the light strip Determine the length of the light strip that needs to be installed, and then take an integer based on the installation length for truncation. The common light strip we use is usually a unit of 1m, so when we cut it, we need to ensure that this unit is not damaged. This requires cutting from the cutting edge, so as not to affect the circuit. If we arbitrarily cut it, it may cause some of the lamp beads to not light up. Therefore, the first step is to determine the length and then take a cut Fixed. 

Due to the fact that the light strips we use at home do not consider waterproofing, as they are installed in our ceiling grooves, the installation method is very simple. For example, the LED light strips we commonly see have self-adhesive strips on their backs. We can use its self-adhesive tape to directly stick it into the groove Connection of light strips. After we use self-adhesive to stick the light strip into the groove of our ceiling, we can now connect the light strip. If we are concerned about the movement of the light strip, we can use some double-sided tape to fix it. Finally, press it flat and fix it by hand. At this point, we need to connect the light strip. LED light strips are usually a circuit structure composed of three LEDs in series or parallel, so we directly disconnect these parts. If there is a joint in the middle, special soldering methods must be used for connection. But try to avoid this situation as much as possible, and try to install the entire section of the light strip.